The terminology of stamping

  • First, deep drawing: a stamping process in which straight wool or process parts are turned into hollow parts, or the hollow parts are further changed in shape and size. During deep drawing, the hollow part is mainly formed by the material located outside the bottom of the convex die flowing into the concave die.
  • Second, trimming: a stamping process that uses a metal stamping die to trim the edge of the forming process to make it have a certain diameter, a certain height or a certain shape.
  • Third, punching: a punching process that separates the waste from the material or process part along the closed contour, and obtains the required hole in the material or workpiece.
  • Fourth, flanging: A stamping process in which a short side is turned into a short side along the contour curve.
  • Fifth, hole turning: a punching process that turns the material into a side flange around the inner hole.
  • Sixth, blanking: a stamping process that separates materials along a closed contour. The separated materials become workpieces or process parts, most of which are flat.
  • Seventh, shaping: relying on the flow of materials, a small amount of changes in the shape and size of the process parts to ensure the accuracy of the workpiece is a stamping process.

Link to this article:The terminology of stamping

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki,Thanks!^^


Bolts are used for fastening in machinery, construction, and electrical industries. One end is a hexagon head for wrench fastening, and the other end is a thread. The length of the thread varies accor…

High-strength bolts can bear a larger load than ordinary bolts of the same specification. The material of ordinary bolts is made of Q235 (that is, A3). The material of high-strength bolts is 35# steel…

What kind of oil is used for aluminum stamping? Should I use fast-drying aluminum stamping oil, slow-drying special oil for aluminum stamping, or non-volatile aluminum stamping oil? This need is speci…

Before stamping, the stamping parts are leveled and then stamped. Not only the feeding precision is high, but also the flatness will be better. Flatness refers to the deviation of the height of the ma…

The surface and internal properties of the sheet metal used for stamping have a great impact on the quality of the stamping product. The thickness of the stamping material is required to be accurate a…

(1) Select the installation reference parts. When installing, first select the reference parts. The principle of selecting reference parts is to determine according to the dependence of the main mold …

1. Draw drawings to determine output Whether metal or plastic mold parts are produced, the drawings and production output need to be determined before production. This step is to determine which produ…

1. stamping die design. The raw material of aluminum stamping parts, aluminum, is relatively soft. When stamping parts are used for stamping, it is easy to cause material blocking. Therefore, when des…

Precision metal stamping parts are stamped from non-ferrous metals and other materials into the required shape and size by external force, and then cut and separated. The materials, stamping dies and …

The size and shape of the process incision depends on the area in which it is located and the requirements for external supplementary materials. Generally, the following principles should be followed:…

(1) According to the drawing of the workpiece, analyze the shape characteristics, size, precision requirements, raw material size and mechanical properties of the workpiece, and combine factors such a…

(1) Since silicon steel plate is a material that is relatively easy to stretch, low-viscosity stamping oil will be used on the premise of preventing scratches for the easy cleaning of the finished wor…

Author: Moldwiki