Introduction to stamping design standard knowledge

  • 1. When designing metal stamping parts, it should be ensured that under normal use, the dimensional accuracy and surface roughness requirements should be as low as possible, and it should be beneficial to the exchange between metal stamping parts, reducing waste, and ensuring Stable quality of metal stamping parts.
  • 2. When designing metal stamping parts, the existing equipment, process equipment and procedures should be used as much as possible to process the metal stamping parts, and at the same time, it should be beneficial to prolong the service life of the stamping die.
  • 3. The designed stamping parts must be beneficial to improve the utilization rate of metal materials, reduce the variety and specifications of materials, and reduce the consumption of materials as much as possible; use low-cost materials where permitted, and make the parts as waste-free and as possible. Less waste arbitration.

The stamping parts manufactured by precision metal stamping are widely used in various industries, such as auto parts, mobile phone batteries, electronic circuit boards, etc., which play an important role and are indispensable equipment accessories.

Link to this article:Introduction to stamping design standard knowledge

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki,Thanks!^^

Bolts are used for fastening in machinery, construction, and electrical industries. One end is a hexagon head for wrench fastening, and the other end is a thread. The length of the thread varies accor…

High-strength bolts can bear a larger load than ordinary bolts of the same specification. The material of ordinary bolts is made of Q235 (that is, A3). The material of high-strength bolts is 35# steel…

What kind of oil is used for aluminum stamping? Should I use fast-drying aluminum stamping oil, slow-drying special oil for aluminum stamping, or non-volatile aluminum stamping oil? This need is speci…

Before stamping, the stamping parts are leveled and then stamped. Not only the feeding precision is high, but also the flatness will be better. Flatness refers to the deviation of the height of the ma…

First, deep drawing: a stamping process in which straight wool or process parts are turned into hollow parts, or the hollow parts are further changed in shape and size. During deep drawing, the hollow…

The surface and internal properties of the sheet metal used for stamping have a great impact on the quality of the stamping product. The thickness of the stamping material is required to be accurate a…

(1) Select the installation reference parts. When installing, first select the reference parts. The principle of selecting reference parts is to determine according to the dependence of the main mold …

1. Draw drawings to determine output Whether metal or plastic mold parts are produced, the drawings and production output need to be determined before production. This step is to determine which produ…

1. stamping die design. The raw material of aluminum stamping parts, aluminum, is relatively soft. When stamping parts are used for stamping, it is easy to cause material blocking. Therefore, when des…

Precision metal stamping parts are stamped from non-ferrous metals and other materials into the required shape and size by external force, and then cut and separated. The materials, stamping dies and …

The size and shape of the process incision depends on the area in which it is located and the requirements for external supplementary materials. Generally, the following principles should be followed:…

(1) According to the drawing of the workpiece, analyze the shape characteristics, size, precision requirements, raw material size and mechanical properties of the workpiece, and combine factors such a…

Author: Moldwiki